TenTec
[Top] [All Lists]

Re: [TenTec] usb to serial

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] usb to serial
From: "Mike Brown" <k9mi@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 16 May 2006 05:13:41 +0100
List-post: <mailto:tentec@contesting.com>
ByteRuner makes some pretty good products also. I've had a pci 2 serial and
1 lpt card combo for over 10 years now, and still running strong. It's been
in and out of a lot of different computers. The XP drivers work fine also.
But as time marches on, I think we are all going to have to use the USB to
serial adapters.Time marches on.  But, I'm still hanging on to my 3 low
speed Pentiums with ISA ports as "spares" also.

73, Mike K9MI

----- Original Message ----- 
From: <CATFISHTWO@aol.com>
To: <tentec@contesting.com>
Sent: Sunday, May 14, 2006 9:24 PM
Subject: Re: [TenTec] usb to serial


>
> In a message dated 5/14/2006 10:16:27 A.M. Pacific Daylight Time,
> k4ymq@yahoo.com writes:
>
> Jack  I've had problems with usb to serial adapters, If you can the better
> option is  to put a 1 or 2 port serial port card in computer, about $25
from
> Tiger  electronics I think
> Ira
>
> jack <jfriend31@comcast.net>  wrote:
> i remember some discussion of USB to Serial adapters. would  you please
> inform me what particular model works and where to get it.
> thank  you
> jack  ak7o
> _______________________________________________
>
>
>
> I have done this and it works well, but you do have to go into "add
> equipment" part of windoze and add each additional port one at a time, and
then  tell
> windoze its there. easy enough,  a bit of a pain, but dooable
>
> tom N6AJR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>