TenTec
[Top] [All Lists]

Re: [TenTec] Relay for Corsair, argosy

To: tentec@contesting.com
Subject: Re: [TenTec] Relay for Corsair, argosy
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Reply-to: geraldj@storm.weather.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 18 May 2006 22:14:23 -0500
List-post: <mailto:tentec@contesting.com>
On Wed, 2006-05-17 at 21:31 -0500, James Duffer wrote:
> I am assuming that you are going to use the supplied power cable, that has 
> an extra pair of wires, if you do you could just connect the pair that is 
> routed to the power switch on the  Corsair, in series with the astron power 
> on/off switch.  Leaving the astron power switch in the ON position, you 
> would then have control of the power to the Corsair with the Corsair 
> AF/Power control.  You may have been considering installing a relay in the 
> Corsair utilizing the AF/Power control if so my advice is of no use.
> 
> Good luck with the project.
> 
> Jim, de wd4air

The radio switch controlling the AC primary of the power supply is
exactly how Tentec intended it to be used. I use a master station supply
for several radios and tncs and so I used the relay in the new cable
that I made for my Corsair II.

The cube automotive relay that I used probably came from Hosfelt, but it
sold in every auto parts store as well as from Mouser and Digi-Key,
often for as little as $3 or 4.

-- 
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>