TenTec
[Top] [All Lists]

Re: [TenTec] Century 21 Tuning Knob

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Century 21 Tuning Knob
From: Bwana Bob <wb2vuf@qsl.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 08 Sep 2006 22:25:17 -0400
List-post: <mailto:tentec@contesting.com>
I think the size is 0.050. I agree, the best fix is the rebuild kit. 
Shortcuts will be short-lived. You may have worn bearings inside and 
usually the old grease has dried out.

                                Bob WB2VUF

wa3fiy@radioadv.com wrote:
> A very small hex wrench.  Don't know exactly what size but it is small.
> 
> There are various opinions about un-sticking stuck PTO shafts.  In mine, 
> the alcohol MAY work but I would not bank on it working very long.  I have 
> tried a number of different ways of freeing PTO shafts over the years and in 
> my experience, the best results have been to do the Ten Tec 
> recommended rebuild.
> 
> 73,
> 
> -Lee-
> WA3FIY
> 
> On 8 Sep 2006 at 16:26, jfelts wrote:
> 
>> Got my C21 about an hour ago, its stuck on the low end of the dial, about 
>> 14017 on 20m.  It recieves, and it transmits.
>>
>> How the heck do you get the main tuning knob off? I've tried small screw 
>> drivers in case it uses set-screws. I've tried allen wrench and don't seek 
>> to hit the center. I think if I can get the knob off I can dribble some 
>> alcohol down the PTO shaft it will free.  It will move a tiny bit either 
>> way.
>>
>> Jerry - NR5A - South Dakota 
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>>
>> -- 
>> No virus found in this incoming message.
>> Checked by AVG Free Edition.
>> Version: 7.0.405 / Virus Database: 268.12.2/442 - Release Date: 9/8/2006
>>
> 
> 
> 
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>