TenTec
[Top] [All Lists]

Re: [TenTec] Noise Reduction Setting

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Noise Reduction Setting
From: Chas Nagel <cnagel@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 4 Dec 2006 18:22:30 -0800 (PST)
List-post: <mailto:tentec@contesting.com>
Thanks, Emil. My Orion I, using 1.372, had good NR. Perhaps TT will address the 
problem in future Orion II firmware updates.
   
  Charles, K0CW

Emil Borys <eborys@martinauto.com> wrote:
  Charles and Kim,
I have a new O II, current firmware, purchased from TenTec about a month
ago. I also have experienced the same phenomenon with the DSP NR.
Regardless of signal levels, Atten, RF Gain, and Audio settings.. even with
DSP at 1.. a CW signal becomes distorted when enabling DSP NR. 

Seeing that CW is virtually my only mode of operation, it is somewhat
disquieting, pun intended, that an advertised feature doesn't function. I
called TenTec and spoke, briefly, to someone in their 'service' department,
about the malfunction. I received a rather gruff and abrupt, "There's
nothing wrong with the Orion, read the owner's manual, goodbye."

If you gentlemen come up with a set of control parameters that allow the use
of DSP NR with CW, please post your solution.

Thanks and 73,
Emil
W9NM


>>>> 
Kim,

Under the same conditions when the NR is on in any position I have raspy
CW reception. Do you experience the same with your Orion II NR?

Charles, K0CW

Kim Elmore > wrote:
I have the O II, 2.037J firmware. The manual says that different 
noise reduction settings affect how long the DSP takes to decide 
what's nose and what's signal, but that the end result is the same. I 
thought this odd, because it seems there's no point in using anything 
but the "fastest" setting.

In playing with it on CW, this doesn't appear to be the case: 
different settings definitely result in different amounts of noise 
reduction, and the lower settings seem to do their job immediately, 
but not as aggressive as the higher settings. Intuitively, this is 
what I'd expect.

Has the NR changed in later firmware versions and the manual failed 
to keep? Or, has the manual always been in error?

Cheers,

Kim Elmore, N5OP 
<<<< 



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>