[TenTec] OMNI VII What if...about 'Flash Update Mode'

[<dbp@tds.net>]

Hi-
What if I want to update the flash memory, but when I go thru the sequence to 
enter the Flash Update Mode, it will not indicate "Flash Update Mode"?

What if at turn on the rig reverts to "Radio not programmed" after receiving an 
initial message: "Retreiving Boot Setup"?

What if using the "Master Reset" sequence has no effect?

A little glitch to get started.

73 de Dave
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec