After booting the radio with the 0 key held, just go ahead and run update
anyway. I had this happen to me once and everything straightened itself out
after I re-loaded the firmware using the tentec update program. The update
program didn't like the "radio not programmed" state when the update
finished. So I ran update a second time and all has been well since. I am
suspicious that a static spark from my finger may have caused all this but
I'm not sure.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: <dbp@tds.net>
To: "Tentec reflector" <tentec@contesting.com>
Sent: Saturday, April 07, 2007 9:42 AM
Subject: [TenTec] OMNI VII What if...about 'Flash Update Mode'
> Hi-
> What if I want to update the flash memory, but when I go thru the sequence
to enter the Flash Update Mode, it will not indicate "Flash Update Mode"?
>
> What if at turn on the rig reverts to "Radio not programmed" after
receiving an initial message: "Retreiving Boot Setup"?
>
> What if using the "Master Reset" sequence has no effect?
>
> A little glitch to get started.
>
> 73 de Dave
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|