OK. I thank you very much.
Bruce - W8FU
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Ron Castro
Sent: Tuesday, May 01, 2007 12:01 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] New Orion II firmware
The letter you see was not in the previous versions. It tells you the
band-stack register you are using. If you repeatedly press the band
button,
you'll see the letter toggle from A through D.
Another thing you see are the letters SPL that appear on the left of the
screen when you're operating split.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "Bruce McLaughlin" <bmclaugh@buckeye-express.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Monday, April 30, 2007 8:54 PM
Subject: [TenTec] New Orion II firmware
>I installed the new firmware tonight. Unfortunately, I don't think the
> noise reduction works as well as the previous version but I will need
> more time to be sure. And what is that strange new small blue box
with
> a "B" in it just above the VFO A frequency readout? That was not
there
> in the previous version of firmware?
>
>
>
> Bruce - W8FU
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|