I found the same problem with Ham Radio Deluxe. When I click on a DX spot,
it moves to that frequency, but will shows the original frequency until I
touch the knob.
73,
John
_____
From: orion565@yahoogroups.com [mailto:orion565@yahoogroups.com] On Behalf
Of Martin Kratoska
Sent: Thursday, May 17, 2007 4:58 AM
To: orion565@yahoogroups.com
Subject: [orion565] 2.061f computer control problem
Dear Orioners,
since update to 2.061f a new problem appeared: if clicking onto spot in
my favorite logging program the radio tunes properly, the program
displays corect frequency but the main display on the radio stays on
previous frequency. A short touch to main tuning knob corrects this
problem, the main display jumps to the correct freuency.
Tested with Logger32 and xdx/xlog/hamlib in linux - both the same. No
problems with 2.060b and below. Master reset does not cure the hanging
display.
Anybody has similar problems?
Otherwise also noted a distortion on strong signals if the AGC response
set to FLAT. I appreciate the NR function which shoes a significant
improvement (compared to 2.060b). The CW sidetone artifacts also nearly
completely (90%) disappeared.
73,
Martin, OK1RR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|