| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] (Orion) firmware update with serial port-less computer |
| From: | "George" <goofyham@highstream.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 21 May 2007 07:50:45 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
I just bought a new mother board at Dayton. I knew that it did not have any COM ports. I need 4 com ports to run my hamshack, O2, rotor, packet, etc. What is the best way to get 4 com ports, board or 4 individual USB to com converters? If I go with the individual converters I'll need a USB expansion board. Suggestions? Thanks. George W2YJ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] When did Ten-tec switch to Schottky diode ring mixers?, Steve Hunt |
|---|---|
| Next by Date: | Re: [TenTec] (Orion) firmware update with serial port-less computer, d . e . warnick |
| Previous by Thread: | Re: [TenTec] (Orion) firmware update with serial port-less computer, Grant Youngman |
| Next by Thread: | Re: [TenTec] (Orion) firmware update with serial port-less computer, Carl Moreschi |
| Indexes: | [Date] [Thread] [Top] [All Lists] |