I don't crimp my APP connectors...I solder them...
and I agree about the brass bolts
----- Original Message -----
From: "Paul Christensen" <w9ac@arrl.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Tuesday, May 29, 2007 2:38 PM
Subject: Re: [TenTec] Cautionary Tale: Orion 13.8 V connector (long)
>> My current Omni 6, I pulled out the dc cable connector and installed
> a pig tail with a much stouter dc connector...30 amp power poles.
>
> As a pig-tail, this is probably fine. However, I have measured as much as
> ~
> 0.3 VDC dropped across properly crimped, standard-sized Anderson PP
> connectors under 12VDC/20A loads. In some instances, the very act of
> crimping will bend the contact surface such that it is no longer in-line
> with the barrel. The result is that the contacts may not mate evenly.
> After each crimp, I check for barrel-to-contact alignment. It's really a
> shame that such extraordinary measures are required to properly seat the
> APP
> and keep them mated.
>
> I cannot imagine the APP connector being used directly on the rear panel
> of
> a transceiver, although one manufacturer is about to release a 100W rig in
> July with APP panel connectors. Since heavy gauge wire is generally used
> for powering, the slightest movement of the radio may be enough to
> slightly
> unseat the connector and that's something you don't want to see at 20A
> while
> transmitting. Since the APP is a non-locking device, I've seen them weld
> together while they are inadvertently flexed under high-current
> conditions.
>
>
> A APP connector that appears to behave fine, may be on the ragged-edge of
> acceptable conductivity. The way to know for sure is to measure the
> voltage
> drop across the connector under full load.
>
> While at Dayton, I noticed that the folks at DCPwr.com had a nice power
> distribution panel with 80-amp APP connectors. While we do not need
> 80-amp
> connectors for the 100W class of radios, I find that the high capacity APP
> connectors offer much better mechanical rigidity than the junior sizes.
>
> http://www.dcpwr.com/products/product.php?id=134
>
> Personally, I would be perfectly happy with insulated, quarter-inch brass
> bolts placed on the back of the transceiver, allowing the owner to connect
> directly from the bolts to the power supply, or as you have done to your
> Omni Six, add the connector of your choice as an in-line pig-tail.
>
> Paul, W9AC
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|