I don't have that here with 2062a. I am not using the bandscope, though.
Bob W2WG
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Owen S. Garner
Sent: Tuesday, June 05, 2007 1:35 PM
To: tentec@contesting.com
Subject: [TenTec] V 2.062a Orion 565AT
Does any one have the same problem I have with V 2.062a? When I attempt to
change bands or modes after a few minutes of operation, all signals are lost
from the audio and the band scope, yet the rest of the display appears
normal. Turning the Orion off, and back on after an hour or so, restores
the signals, only to be lost again after a few minutes when attempting a
band change. Master resets do not help. I reloaded V2.059, and the rig
works normally,with no problems changing bands or modes. Meanwhile, I am
living with V 2.059
K1AF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|