| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Gauge of wire from power supply question? |
| From: | "MICHAEL SOUHRADA" <wb9iog@msn.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 6 Jun 2007 14:24:55 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Dan FYI I use some brass tubing to do that. Takes a bit of fiddling but I had some old brass ball pen tubes that fit. Mike Iowa BTW #10 can handle 25 A do you need that much? ----- Original Message ----- From: <OTAKEBI@aol.com> To: <tentec@contesting.com> Sent: Wednesday, June 06, 2007 2:10 PM Subject: Re: [TenTec] Gauge of wire from power supply question? _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| Previous by Date: | Re: [TenTec] Gauge of wire from power supply question?, OTAKEBI |
|---|---|
| Next by Date: | [TenTec] OMNI VII Review on ARRL site......., fraz1 |
| Previous by Thread: | Re: [TenTec] Gauge of wire from power supply question?, OTAKEBI |
| Next by Thread: | Re: [TenTec] Gauge of wire from power supply question?, Paul Gates, KD3JF |
| Indexes: | [Date] [Thread] [Top] [All Lists] |