| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] RX-10 Operation |
| From: | John Graves <jh.graves@verizon.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 28 Jul 2007 10:16:05 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
I have a RX-10 that I am going through. A PO had installed nicads as a power source and they are over the hill. I was checking operation last night and heard signals on 20 & 40. The Tune control works but as I turn it towards the band of operation, it seems to cause an oscillation just at the point of peak signal strength. Is this normal? John / WA1JG _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Technical Correspondence, Henry Mackey |
|---|---|
| Next by Date: | Re: [TenTec] Technical Correspondence, Mike Gorniak |
| Previous by Thread: | Re: [TenTec] David Barlow WA6CQJ (SK), ARDUJENSKI |
| Next by Thread: | Re: [TenTec] RX-10 Operation, Gary E Norman |
| Indexes: | [Date] [Thread] [Top] [All Lists] |