Yes, you are correct. But you can also run the Omni VII and an rx320
receiver together using my N4PY software for full dual receive. My software
will marry the 2 radios together so it will work as though the Omni VII had
a sub-receiver like the Orion. And yes, the Orion sub-receiver volume is
independent of the main receiver volume.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, October 02, 2007 1:14 PM
Subject: Re: [TenTec] dual receive
> Ross, I believe you're correct. With the Orions, you actually have
> two separate receivers and all operating controls are independent and
> adjustable.
>
> 73,
> Barry N1EU
>
> On 10/2/07, kdl8932 <w6fg@pacbell.net> wrote:
> > Hello All,
> > One of the things I liked best about the older T-T rigs was the dual
receive feature. What a great weapon when digging into the pile-ups! I
assume that the only current Ten-Tec rig with that capability is the Orion.
Can anyone confirm this? Secondly, when using this mode with the Orion (both
Orion and Orion II?) are the volumes of each frequency totally independent
of each other and individually adjustable? I love my Omni VI opt 3 but I
dooo miss dual receive.
> > Tnx for replies,
> > Ross
> > W6FG
> >
> >
> > ~*~*~*~*~*~*~*~*
> > Time flies like arrows... Fruit flies like bananas!
> >
> > www.radiocycle.crazyguyonabike.com
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|