TenTec
[Top] [All Lists]

Re: [TenTec] Digital (PSK31) Communications

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Digital (PSK31) Communications
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 2 Feb 2008 10:38:41 -0600
List-post: <mailto:tentec@contesting.com>
A comment to the point of setting vs. controlling the power on the Jupiter.

For modes like PSK-31 the Jupiter should be configured to operate at its rated output power or 100 watts. Then the actual power output should be controlled by the PSK-31 software or the sound card output level or interface output level to the Jupiter so as to cause the Jupiter to produce some 25 to 35 watts of power. This will prevent the ALC activation and subsequent distortion from being generated and transmitted. Also, any SP or speech processing should be OFF.

It should be noted that the PSK-31 signal will cause the power output to vary slightly depending on if idle or data is being transmitted. This is normal and the amount of variation depends on several factors, such as tone frequency, power meter response and dampening and etc.

Here is the basic NO NO. Reduction of the Jupiter power to 25 to 35 watts and then have the sound card audio drive the Jupiter to 25 to 35 watts will activate the ALC and subsequent distortion of the transmitted signal will likely result. This produces a transmitted signal that is several hundred Hz wide and thus an annoyance or interference to others on the band.

In general it is frowned upon to run "high power" on PSK-31. The issue with this lies in the fact that an exceptionally strong signal adjacent to a weak signal, both within the IF passband, will cause the strong signal to capture the AGC and thus further suppress the weaker signal. As a general "rule of thumb" one should always operate with actual PSK-31 power output being no more than 25% to 35% of the rated transmitter power.

73
Bob, K4TAX




----- Original Message ----- From: "ron" <roncasa@verizon.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, February 02, 2008 9:42 AM
Subject: Re: [TenTec] Digital (PSK31) Communications


Henry Mackey wrote:

The power setting on the Jupiter was at 100%. However, I would reduce the power according to the rigs meter to 20-25 watts and avoid any ALC.




25 watts??

For a mode that only needs minimal wattage??
Try less and be amazed. (the spectrum would also be cleaner if we all did)
(smile)

Ron
"the 516 is a keeper"
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>