Hi Carl and the group.
I'm the guy that sold the VFO to Lu.
My brain was not in gear and I thought he was setting up a 544
and not a 244 digital readout. I was very disappointed to see his
post yesterday.
I had a document sheet from TT "Service Note SN-1-540" that
I should have sent along; I did last night and hopefully that will
resolve the problem. There are some jumper modifications on the
244 plug needed. It also covers the 240,241 in addition to the 242,
244 hook up.
If anyone needs this three page document It's available from me
in .pdf form. Not the best quality but understandable. Ask and you
shall receive.
Also wonder if there is a corresponding sheet for the 244? I don't
need it but would like to add to my manual file just in case.
Mike
Iowa
----- Original Message -----
From: Sferic@aol.com<mailto:Sferic@aol.com>
To: KC2RVD@arrl.net<mailto:KC2RVD@arrl.net> ;
tentec@contesting.com<mailto:tentec@contesting.com>
Sent: Wednesday, March 26, 2008 6:49 AM
Subject: Re: [TenTec] 242 VFO Problem...
I recall the early Triton IV's needed an internal mod to work with the remote
VFO. Ten-Tec should have that information. If not, I could probably dig it up
for you.
Carl, K4SEV.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|