On Wed, 2008-08-13 at 09:17 -0700, David Cuttler wrote:
> I just acquired a 229A tuner, and I can see that I will have an issue
> regarding the panel lights. If I use an RCA plugged cable to my Corsair II
> everything will be fine. The panel lights will be on when the Corsair II is
> on. Here is where it gets sticky. If I want to use some other hf rigs, It
> will require leaving the Corsair II on all the time just to power the panel
> lights.
>
> I thought about hooking the tuner up to a wall wart, and just leaving it on
> all the time, but that will shorten the bulb life, and also consume power 24
> hours a day at a time when everyone should be conserving power.
>
> I am about to drill two holes next to the RCA socket, and install a modern
> socket in parallel to match the common plug used on most of the 12V wall
> warts, leave the tuner powered up from the wall wart and also install a push
> button switch to turn the panel lights on when required. I do not have a
> problem modifying my stuff, because I am not saving it for the next collector.
>
> If someone has a better idea, I am all ears.
>
> David Cuttler – KE6YX
>
>
Install a master switch for the whole hamshack. Then the wall wart works
simply and when you shut down, you open the master switch taking power
off all but the clock (or go to a battery clock, I compute one AA
alkaline every two years is cheaper than 3 watts 24/7/52). A good outlet
strip can be that master switch for a beginning.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|