DW
The 705 does not need the battery; it gets its power from the rig.
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Don Steele
Sent: Tuesday, January 06, 2009 7:27 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] TT 705 Mic
DW, The 705 should be wired to plug directly into the Omni 6. It uses the
pre amp and should obtaing its power from the rig.
Don
NT0F
----- Original Message -----
From: "DW Holtman" <tubestuff@comcast.net>
To: <n2wjw@yahoo.com>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Tuesday, January 06, 2009 5:52 PM
Subject: [TenTec] TT 705 Mic
> Hello,
>
> I just aquired a Omni VI Plus and from a different source, I have a 705
> mic.
> I'm not familiar with thie mic. It has a circuit board (pre-Amp) built in.
> My question, should I use the pre-amp or bypass it and connect the output
> directly to the Omni VI?
>
> Thank you in advance for any advice.
>
> Best,
> DW Holtman
> WB7SSN
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|