| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] OT Again: Eico 710 GDO |
| From: | John Graves <jh.graves@verizon.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 30 Jan 2009 22:11:23 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
My Eico 710 GDO has died. No response to changing coils. Dial light
comes on when turned on. I have found a users manual but not the
building manual. Does anyone have assembly or disassembly instructions?
-- John Graves WA1JG jh.graves@verizon.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Omni 6 Rig control, Roger Hughes |
|---|---|
| Next by Date: | Re: [TenTec] Orion II....AUX I/O Direct to Computer for Digi?, Roger Hughes |
| Previous by Thread: | [TenTec] G5RV, Douglas G. Bonett |
| Next by Thread: | Re: [TenTec] OT Again: Eico 710 GDO, Dr. Gerald N. Johnson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |