This goes back a few years. Kit $29.95, wired $49.95.
Mike
W8TRN
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: <tentec@contesting.com>
Sent: Saturday, January 31, 2009 10:15 AM
Subject: Re: [TenTec] OT Again: Eico 710 GDO
On Fri, 2009-01-30 at 22:11 -0500, John Graves wrote:
My Eico 710 GDO has died. No response to changing coils. Dial light
comes on when turned on. I have found a users manual but not the
building manual. Does anyone have assembly or disassembly instructions?
My guess would include a failed tube, probably a 6AF4 UHF tuner triode,
or a broken cable if the power supply is separate from the dipper.
Getting into the dipper probably requires removing the screws through
the U shaped wrapper and sliding it off the bottom. Don't take out
screws that don't hold that wrapper on.
Could be a power supply problem too, but the tube is the most likely
failure.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|