Todd,
Have you used that SAME setup before to update te OII?
If so...check all you com settings in windows. Run no other applications at the
same time.
If that setup has not ben used...you may just have a USB-serial that's not FB.
I hope your not on Vista?
73,
Lee
-----Original Message-----
From: M. Todd Miskel <foamhand@hotmail.com>
To: Ten Tec <tentec@contesting.com>
Sent: Fri, 27 Feb 2009 6:14 am
Subject: [TenTec] 2.041 updating problem...need help
i all, I have been trying for an hour and a half to get my OrionII to take the
ew program but the radio never shows the lines of code it's receiving, It just
hows the Flash memory mode screen / press any key to exit. Meanwhile, The
omputer is showing that it's talking to the radio VERY SLOWLY...like 10 to 20
ines of code every 5 minutes. but the radio shows nothing. I am using a Rat
hack USB to Serial adaptor and have installed all pertinet firmware. I have 3
SB ports on my laptop with 2 already occupied with a mouse and audio setup, so
selected COM3 in the program. If I select any other COM the warning that
ommunication with the radio has failed etc. Any suggestions of where i'm going
rong? 73, Todd - KT0DD
________________________________________________________________
indows Live™: Discover 10 secrets about the new Windows Live.
ttp://windowslive.com/connect/post/jamiethomson.spaces.live.com-Blog-cns!550F681DAD532637!7540.entry?ocid=TXT_TAGLM_WL_t2_ugc_post_022009
______________________________________________
enTec mailin
g list
enTec@contesting.com
ttp://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|