This may be a clue. Serial port interrupt settings may be incorrect.
http://tldp.org/HOWTO/Serial-HOWTO-18.html
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of John
Sent: Friday, February 27, 2009 9:02 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 2.041 updating problem...need help
Hi Todd that sounds exactly like my situation here . No success yet
----- Original Message -----
From: "M. Todd Miskel" <foamhand@hotmail.com>
To: "Ten Tec" <tentec@contesting.com>
Sent: Friday, February 27, 2009 6:14 AM
Subject: [TenTec] 2.041 updating problem...need help
Hi all, I have been trying for an hour and a half to get my OrionII to take
the new program but the radio never shows the lines of code it's receiving,
It just shows the Flash memory mode screen / press any key to exit.
Meanwhile, The computer is showing that it's talking to the radio VERY
SLOWLY...like 10 to 20 lines of code every 5 minutes. but the radio shows
nothing. I am using a Rat Shack USB to Serial adaptor and have installed all
pertinet firmware. I have 3 USB ports on my laptop with 2 already occupied
with a mouse and audio setup, so I selected COM3 in the program. If I select
any other COM the warning that communication with the radio has failed etc.
Any suggestions of where i'm going wrong? 73, Todd - KT0DD
_________________________________________________________________
Windows LiveT: Discover 10 secrets about the new Windows Live.
http://windowslive.com/connect/post/jamiethomson.spaces.live.com-Blog-cns!55
0F681DAD532637!7540.entry?ocid=TXT_TAGLM_WL_t2_ugc_post_022009
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|