Once mine goes red...I have to turn sweep off/on to get it going right
again...That's not a feature.
73,
Lee
-----Original Message-----
From: Stuart Rohre <rohre@arlut.utexas.edu>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Mon, 9 Mar 2009 4:21 pm
Subject: Re: [TenTec] NEW Orion II/2.041XL Bug? Red Scan With
VerticalLinePatterns
Didn't someone point out that a type of sound card software uses a red
screen to indicate when there has been an overload in the signal path?
A number of sound card programs work this way. Transient signals have
been reported just before someone notices the red screen. I would say
this is a reasonable warning signal that too much gain, or a very large
transient has been received.
Stuart
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|