TenTec
[Top] [All Lists]

Re: [TenTec] R-320 Question

To: <geraldj@storm.weather.net>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] R-320 Question
From: "DW Holtman" <tubestuff@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 16 Mar 2009 22:02:27 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hello,

Thanks for the responses. I built a cable and the RX-320 works great. It is 
an amazing receiver.

Best,
DW Holtman
WB7SSN

----- Original Message ----- 
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: <tentec@contesting.com>
Sent: Monday, March 16, 2009 4:30 PM
Subject: Re: [TenTec] R-320 Question


> On Mon, 2009-03-16 at 16:05 -0600, DW Holtman wrote:
>> Hello,
>>
>> Quick question. Is the serial cable from an R-320 a straight cable? That 
>> is,
>> is pin 1 wired to pin 1 etc?
>>
>> Thank you,
>> DW Holtman
>> WB7SSN
>>
> Pins 1 and 7 on a 25 pin serial cable are chassis and signal grounds.
> They are always wired straight. 2, 3, 4, 5, 6, 8, and 20 are signals
> that are sometimes crossed. Much the same applies to 9 pin but I don't
> have those pin numbers memorized.
>
> 73, Jerry, K0CQ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>