Hello everyone,
Just signed on and I find (as usual) about 25 e-mails, most of which are
complaints about TENTEC or their products.
My suggestion would be to sell all your TENTEC gear and replace it with one of
the perfect, problem free RICE BURNERS that are readily available and never
have any problems of any kind. In the event you do have one of those rare
problems with your more expensive JAPANESE JUNK, be assured the service you get
from them will be so much better than TENTEC.
All of you need to get a life outside of ham radio and computer geeking.
73 to all from a very happy and satisfied O11 owner.
Harry w4wst
---- N1IX <n1ix@n1ix.com> wrote:
> That's good for us. It will keep TenTec as a viable company in these bad
> economic times.
>
> Dave N1IX
>
> ----- Original Message -----
> From: "Duane Calvin" <ac5aa1@gmail.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Friday, May 15, 2009 5:50 PM
> Subject: Re: [TenTec] 2.041XT FW Follow-up
>
>
> > I'll summarize Scott's response this morning to one of my questions
> > was that TT has been very busy supplying gov't and military customers.
> >
> > 73, Duane
> >
> >
> > Sent from my iPod in Dayton
> > Duane C.
> >
> > On May 15, 2009, at 12:15 PM, <jmiller1706@cfl.rr.com> wrote:
> >
> >> I am not sure I want to take the time to download this update.
> >> Doesn't TT understand the concept of disciplined testing, even
> >> before release of a beta version? That means exercising all
> >> possible combinations of paths and user commands. And are they
> >> convinced this "red screen of confusion" is not caused by circuit
> >> noise or transmit RF? Do they even have the manpower to apply to
> >> the Orion II, while apparently dedicating more man-hours to
> >> reintroducing old technology (i.e. speech pprocessors)? I don't
> >> want to be negative on TT, when I bought my O-II I did primarily
> >> because I wanted to support an American company in this onslaught of
> >> Japanese engineering excellence (probably the last American company
> >> we'll see unless K and Flex can survive, and avoid going the way of
> >> GM and Chrysler)... but enough is enough. TT you can't continue to
> >> hobby shop this software,..get disciplined... either get the talent
> >> you need for advanced software radio, or subcontract it out, or drop
> >> it and
> >> throw all your talent into speech processors, or maybe sell out to
> >> MFJ. Get serious!
> >> Jim N4BE
> >>
> >> ---- "Peter Frenning [OZ1PIF]" <peter@frenning.dk> wrote:
> >>> Well, I've just seen the "Red Screen" again (using the AF-AGC) after
> >>> about 30 mins on 80m
> >>> Sweep On/Off cycling clears the condition!
> >>>
> >>> --
> >>> Vy 73 de OZ1PIF/5Q2M, Peter
> >>>
> >>> ** CW: Who? Me? You must be joking!! **
> >>> email: peter(no-spam-filler)@frenning.dk
> >>> http://www.frenning.dk/oz1pif.htm
> >>> Ph. +45 4619 3239
> >>> Snailmail:
> >>> Peter Frenning
> >>> Ternevej 23
> >>> DK-4130 Viby Sj.
> >>> Denmark
> >>> ***********************************
> >>>
> >>>
> >>> _______________________________________________
> >>> TenTec mailing list
> >>> TenTec@contesting.com
> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >>
> >> _______________________________________________
> >> TenTec mailing list
> >> TenTec@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|