TenTec
[Top] [All Lists]

Re: [TenTec] Head-Phone volume in Orion2

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Head-Phone volume in Orion2
From: <ac5aa1@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 28 Aug 2009 06:47:01 -0700 (PDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I have an Orion with the same problem.  I think it is common to the Orion & 
Orion II with low-Z phones. 

  73,  Duane    AC5AA

-----Original Message-----

From:  "Peter Frenning [OZ1PIF]" <peter@frenning.dk>
Subj:  [TenTec] Head-Phone volume in Orion2
Date:  Fri Aug 28, 2009 3:16 am
Size:  697 bytes
To:  Discussion of Ten-Tec Equipment <tentec@contesting.com>; 
orion565@yahoogroups.com

I have the (perceived) problem that the volume from my head-set 
headphones is much lower than the equivalent speaker volume. I'm using a 
Danmike head-set (32 Ohm, 97dB @ 1mW (IEC 318))

Is there any way to adjust the relative output volume between the 
speaker and head phone outputs?

-- 
Vy 73 de OZ1PIF/5Q2M, Peter

** CW: Who? Me? You must be joking!! **
email: peter(no-spam-filler)@frenning.dk
http://www.frenning.dk/oz1pif.htm
Ph. +45 4619 3239
Snailmail:
Peter Frenning
Ternevej 23
DK-4130 Viby Sj.
Denmark
***********************************


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>