As much as I like my Argonaut V, it's not the radio to have on in the
shack 'just to listen' to the bands. It's noisy!
I find if I turn the attn on, then everything is down. I would have
really liked to see a RF gain, or a way to turn the preamp off without
turning the attn on.
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
A man with one clock knows what time it is. A man with two clocks is
never sure.
On Jan 4, 2010, at 10:07 PM, Bill Harris wrote:
Gil:
I find that running with the atten. on, turns off the pre amp, which
works
fine for everything below 17 or 20 meters.
And YES, this rig has a LOT of gain and I find it's not normally
necessary
for the lower bands. However, there are times when use of the pre amp
will
help out on a weak signal, depending on your noise environment.
The receiver takes some getting use too. The high back ground noise
will
drive you nuts and the only way I know of reducing it is to turn off the
pre-amp.
|