THANKS for letting me know your results c ya John
On Jan 12, 2010, at 12:47 PM, Mike Bryce wrote:
> john...
>
> I have one that does the same thing. It's not the radio, it's the 40
> meter module
>
> I found out by subbing in a different module 40 meter module and lo
> and behold, the problem went away.
>
> I popped the module open and did a quick look, looking for a loose
> ground or other problem. never did find one, so when that module is
> used and during tx, the display rolls...
>
>
> doesn't seem to effect the quality of the signal, just makes the
> display wobble
>
>
> Mike, WB8VGE
> SunLight Energy Systems
> The Heathkit Shop
> http://www.theheathkitshop.com/
> J e e p
> o|||||||o
> Note: No trees were killed in the sending of this message, but a large
> number of electrons were terribly inconvenienced
>
>
>
>
> On Jan 12, 2010, at 9:52 AM, John Peters wrote:
>
> I have a scout that is acting up... with the 3,14 and 28 Mc units
> it works just grand.
> But with the 7 Mc unit, I reads freq' and copies signals just fine.
> When I
> go to transmit the freq reads out, goes like it was on a ferris
> wheel. it just
> don't sit still, until I go back to receive..
> Any suggestions ? and which half of the unit is for xmit (the
> xtal for both)
> Thank you John looking for help
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|