| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Scout 555 |
| From: | Stuart Rohre <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 12 Jan 2010 16:40:40 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
John,Check that 40m plug in. Look for loose solder connection around the oscillator/mixer, and the inductors and capacitors of the output low pass filter. Check that there is no metal burr shorting two of the fingers on the edge card connector. Good Luck, Stuart Rohre K5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Restoring backlighting for the Delta II or Its Argo brother???, Stuart Rohre |
|---|---|
| Next by Date: | [TenTec] FS: Price Reduced: microHAM USB Interface III for ORION/ORION II, Charles W. Shaw |
| Previous by Thread: | Re: [TenTec] Scout 555, Bwana Bob |
| Next by Thread: | Re: [TenTec] Scout 555, budw2gln |
| Indexes: | [Date] [Thread] [Top] [All Lists] |