I just found out the problem...bad RCA cable going from the RADIO jack on the
AmpKeyer to the Jupiter. Replaced the cable and no problems!
Thank you for your help. Your reply post made me re-check all jumpers and
cables which did the trick.
Yes, sometimes it's THAT SIMPLE!
73
John - K5ZU
--- On Fri, 1/22/10, Richards <jruing@ameritech.net> wrote:
> From: Richards <jruing@ameritech.net>
> Subject: Re: [TenTec] RF in Ext. Speaker on Jupiter
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Date: Friday, January 22, 2010, 10:04 AM
> Not sure this will help... but my
> last RF from speakers in
> the shack issue was solved by swapping out a problematic
> 3-foot antenna jumper -- and I know you said you checked
> for that, but I had done that several times before I found
> the problem child among all the good ones. It
> checked
> good for continuity and no shorts, but my RF in the
> speaker
> problem quit thereafter. Go figure.
>
> The only way I found it was changed some of the cables
> to different assignments, and the bad one ended up on
> my 2 M mobile which has a straight line to the antenna
> and the problems occurred only when I keyed up on 2M
> and then it was clear which and why and how I was
> getting problems. Swapping it out fixed it
> immediately.
>
> Good luck !!!
>
> ======================= K8JHR
> =====================
>
> On 1/22/2010 10:16 AM, John Serrette - K5ZU wrote:
>
> RF continues to blare through the external speaker.
> >
>
>
> ===================================================
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|