TenTec
[Top] [All Lists]

Re: [TenTec] High speed washer hum/whine

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] High speed washer hum/whine
From: "CSM\(r\) Gary Huber - AB9M" <glhuber@msn.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 3 Feb 2010 17:21:59 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
And if you have more than one electrical panel, only the first panel (Main 
Distribution Panel) has a Neutral - Ground bonding screw in place. All sub 
panels are to have the neutral - ground bonding screw removed (frequently 
not done).

73,

Gary - AB9M

--------------------------------------------------
From: "Jim Brown K9YC" <k9yc@audiosystemsgroup.com>
Sent: Wednesday, February 03, 2010 4:14 PM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] High speed washer hum/whine

> On Wed, 03 Feb 2010 15:27:36 -0600, Stuart Rohre wrote:
>
>>The problem may be Variable
>>Speed Drives in the appliance, lots of modulated semiconductors
>>controlling the motor for "Green" efficiency.  Oh, the laws of
>>unintended consequences from the environmentalists!
>
> Don't blame environmentalists -- it's lousy circuit design.
>
>>There are no guarantees with line filters.
>
> This doesn't sound like a line filtering issue, but it DOES sound
> like possibly improper connections of neutral and the power system
> green wire, or a missing power system green wire, of missing bonds
> of station ground to the rest of what's grounded. These improper
> connections could be in the shack or at the appliance.
>
> Some things to check. 1) Make sure that the green wire is bonded
> to the chassis at the power supplies, AND where the power supply
> is plugged into the AC outlet. 2) Make sure that the chassis
> (green wire) is NOT connected to the neutral.  3) Make sure that
> your power system ground (green wire) is bonded to everything else
> in your station, and that every chassis in your station is bonded
> together. 4) Make sure that the common point of your station
> chassis bonds (grounds) is tied to the ground rods for your
> antenna system, your shack, the power system ground rod, and the
> ground for Telco and CATV arrestors.
>
> Look for #1 and #2 at the appliance that is generating the noise.
>
> 73,
>
> Jim K9YC
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>