Bob, with TenTec Transceivers you do not need a linear ALC connection. This
is because you can set the ALC level at the transceiver to prevent over
driving the linear within a 5 to 100 watt input range. Basically with the
OMNI V series you press the Tune button, then you set the PWR level control
for the desired output (FWD or Ic) and increase the MIC level until the ALC
light comes on. Take the OMNI out of Tune and the ALC level is set as long
as you leave the PWR level at the same level and the MIC at the same or
less.
73,
Gary - AB9M
--------------------------------------------------
From: "Bob AD5VJ" <rtnmi@sbcglobal.net>
Sent: Sunday, February 07, 2010 12:24 AM
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] OMNI VI
I have a drake L-7 amp. In looking at the manual for the OMNI VI I can see
the rear of the radio and see the rly connection, but I don't see an alc
connection. How does one do the alc connection with this radio?
Bob AD5VJ
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-
bounces@contesting.com] On Behalf Of Bob AD5VJ
Sent: Saturday, February 06, 2010 11:29 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: [TenTec] OMNI VI
Can someone pls direct me to a comparison chart between the OMNI VI,
VI+,
VI++
Are they all computer controllable?
Bob AD5VJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|