Thanks for the quick response, proably clean it but i'll pass thanks again
73 john
--- On Tue, 10/5/10, John <fraz1@bellsouth.net> wrote:
From: John <fraz1@bellsouth.net>
Subject: Re: [TenTec] 238A parts tuner....
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Date: Tuesday, October 5, 2010, 8:08 PM
John....the inductor tuning wheel has an arc mark on it from where it was
touching the roller inductor at the time of the hit.
John
----- Original Message -----
From: "JOHN" <ku3g@yahoo.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, October 05, 2010 6:51 PM
Subject: Re: [TenTec] 238A parts tuner....
Is the incutor still good
73 john ku3g
--- On Tue, 10/5/10, John <fraz1@bellsouth.net> wrote:
From: John <fraz1@bellsouth.net>
Subject: [TenTec] 238A parts tuner....
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Date: Tuesday, October 5, 2010, 5:38 PM
It took a lightning hit, but many parts are fine. If you need a part, email
me off-list. Case and front panel are near mint. Variables are fine. Band
switch and rear PCB are toast. Cheap......not looking to make bucks.
Non-smoker ;-).
73 John W4II
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|