Re: [TenTec] 238A parts tuner....

[pfizenmayer <pfizenmayer2@q.com>]

A couple years ago TT sold me a couple new rollers - very reasonable - can't 
remeber but less that $5 .
73 Hank K7HP

----- Original Message ----- 
From: "John" <fraz1@bellsouth.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, October 05, 2010 5:08 PM
Subject: Re: [TenTec] 238A parts tuner....


> John....the inductor tuning wheel has an arc mark on it from where it was
> touching the roller inductor at the time of the hit.
>
> John
> ----- Original Message ----- 
> From: "JOHN" <ku3g@yahoo.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Tuesday, October 05, 2010 6:51 PM
> Subject: Re: [TenTec] 238A parts tuner....
>
>
> Is the incutor still good
> 73 john ku3g
>
> --- On Tue, 10/5/10, John <fraz1@bellsouth.net> wrote:
>
>
> From: John <fraz1@bellsouth.net>
> Subject: [TenTec] 238A parts tuner....
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Date: Tuesday, October 5, 2010, 5:38 PM
>
>
> It took a lightning hit, but many parts are fine. If you need a part, 
> email
> me off-list. Case and front panel are near mint. Variables are fine. Band
> switch and rear PCB are toast. Cheap......not looking to make bucks.
> Non-smoker ;-).
>
> 73 John W4II
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec