Hi Jack....I'm sure you're right. I have not really looked closely at it.
I have a buyer for 50 bucks, plus shipping....as is.
73 John
----- Original Message -----
From: "K2RS" <K2RSonline@comcast.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, October 05, 2010 9:23 PM
Subject: Re: [TenTec] 238A parts tuner....
Hi John.
I'm interested in your 238A. How much would you want for the entire
tuner? I'd take the whole thing as is, if the price is right. You
wouldn't have to part it out.
My only question is about the roller inductor. I know you said there was
a burn on the roller wheel. Are there any burn marks on the roller
inductor wire? I ask because it would seem likely that if the wheel got
burned, where ever it was sitting on the inductor might have gotten
burned too.
I'll look forward to hearing from you.
73,
Jack K2RS
On 10/5/2010 5:38 PM, John wrote:
It took a lightning hit, but many parts are fine. If you need a part,
email me off-list. Case and front panel are near mint. Variables are
fine. Band switch and rear PCB are toast. Cheap......not looking to
make bucks. Non-smoker ;-).
73 John W4II
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|