Snaphat battery and crystal removed. Coin cell holder temporarily lashed up
and fitted with CR2032 lithium battery. No crystal fitted. After initial
resets radio appears to function normally and after power off for a good few
minutes, usually more than enough to invoke the master reset it now behaves
normally. Will leave it overnight and see how it goes. 00:30 here so pulling
the big switch for tonight.
73
Martin, HS0ZED
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Rick W
Sent: 17 October 2010 00:21
To: Ten-Tec Reflector
Cc: hs0zed@csloxinfo.com
Subject: Re: [TenTec] Orion resets at every power up
Check out:
http://lists.contesting.com/archives//html/TenTec/2009-08/msg00024.html
It looks like the xtal is NOT used. I know - I asked the same question?
73,
Rick
VE7TK
Website: http://www.ve7tk.com
----- Original Message ----- From: "Martin Sole" <hs0zed@csloxinfo.com> To:
"'N4PY2'" <n4py2@earthlink.net>; "'Discussion of Ten-Tec Equipment'"
<tentec@contesting.com> Sent: Saturday, October 16, 2010 10:06 AM Subject:
RE:
[TenTec] Orion resets at every power up > There's a battery? Who'd have
thought. I know it says battery failure when > doing a RAM clear but had
assumed
(ha) it was just a way of saying that > the > process had taken place.
Maybe standard device text. > > So where is the battery? Not on the CPU/DSP
board.
What is it's function? > Which schematic is it on? Coin cell? What expected
life? Hopefully > changing > requires no special procedure. Who knows?
Questions questions??!! > > Thanks > Martin, HS0ZED
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|