My N4PY software will control the rx350.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Bruce" <bsugarberg@core.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, November 15, 2010 10:00 PM
Subject: Re: [TenTec] FS: RX-350
> Hello John,
>
> If you look at a picture of the RX-350, you will see that it looks just
> like a Jupiter. The RX-350 is basically the receiver half of a Jupiter.
>
> The RX-350 has a front panel SAM (synchronous AM) button. It also has a
> front panel CW/DIG (CW/Digital) button. On the pack panel is a serial
> port for computer control. The manual does not go into much detail about
> this, other than to say check the Ten-Tec web site for available software.
>
> 73, Bruce WA8TNC
> ================
> John Molenda wrote:
>> Hi , how does this receiver compare to ham radio transceivers . I have a
>> Orion II but vfo B does not have all the filtering or synchronous AM I
>> wonder how they would compare ? Is it capable of Digital radio Mondale
>> ? did I get that right sp ? thanks John Molenda kb2huk
>> ===================================
>> On 11/15/2010 8:34 PM, Bruce wrote:
>>> Hello:
>>>
>>> For Sale: Ten-Tec RX-350 Receiver.
>>>
>>> 100 kHz-30Mhz.
>>>
>>> AM, synchronous AM (with selectable sideband),
>>> FM, USB, LSB, CW.
>>>
>>> IF DSP with 34 filters from 300 Hz to 8 kHz.
>>>
>>> 1024 Memories.
>>>
>>> Spectrum Sweep Display.
>>>
>>> Many other features.
>>>
>>> Condition: Excellent.
>>>
>>> $695.00 (price includes shipping and insurance).
>>>
>>> 73, Bruce WA8TNC
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|