TenTec
[Top] [All Lists]

[TenTec] OT: Open Wire Feedline

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: [TenTec] OT: Open Wire Feedline
From: "Rick - NJ0IP / DJ0IP" <Rick@DJ0IP.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 15 Nov 2010 15:46:51 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Replying to Stuart's comment about openwire, but I changed the title..

When you do not have the Thermopain double-glass windows, but just a single
window, you can build two capacitors using heavy duty aluminum foil or thin
copper plates, and then shoot the signal right through the window.
I made mine out of 4 pieces of doubled aluminum foil, each about 1 sq. ft.
in size, taped to the window.
2 inside, separated about an inch or so, and and 2 outside.
This was 1963/64.
I had no way to measure the loss, but in my skeds and traffic nets, I seemed
to be as loud as I ever was when using direct feed.

73
Rick

---------------------------------------
Twin lead is a great antenna transmission line.  Heavy duty types and 
ladder line are cheaper than good coax and have lower loss.  One can 
easily adpat any station to running balanced line even thru windows with 
good results at little effort.  Putting a piece of pipe insulating foam 
across the bottom of a sill works even with metal windowns.  Another 
piece of foam stuffed between the sash and upper casement seals against 
air leaks.

-Stuart
K5KVH


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>