TenTec
[Top] [All Lists]

Re: [TenTec] Argonaut V-Jupiter-Signalink USB and Digital...reply

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Argonaut V-Jupiter-Signalink USB and Digital...reply
From: "al sirois" <alsirois@roadrunner.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 20 Dec 2010 05:16:06 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Monday 0500 EST

I had the same problem, Jim:

Only I was using the Kam-PLUS and doing g-tor in the MARS program.
I was able to receive, but not transmit.......with the Jupiter.

I solved my problem by going back to my FT_900-AT and the Kam-PLUS.

Now the MARS don't use g-tor, instead they use FT-63 and audio system
And the Jupiter works fine.

73
alsirois@roadrunner.com
N1MHC@arrl.net
Nnn0wna
======================= 

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of James C. Owen, III
Sent: Sunday, December 19, 2010 6:04 PM
To: Ten-Tec
Subject: [TenTec] Argonaut V-Jupiter-Signalink USB and Digital

Not wanting to re-engineer something that likely already has been done.
Here's 
my problem! Recently  got on the digital modes with a signalinkUSB that
works 
fine with the Argonaut V, all gain controls pretty much centered. Connected
to 
the Jupiter and had nothing but overdrive even with all gain controls at 
minimum. I then looked at the spec's of the two. Argonaut V 100mv into 47
ohms, 
Jupiter 1mv into 47 ohms. So the Jupiter is 100 times more sensitive, so
that's 
the problem. I'm thing of a simple T attenuator  which will require me to
make 
another cable. Has anyone come up with a good simple solution?
73 Jim K4CGY



      
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>