Previous reports of Omni 6 logic board failures have stated a IC is no
longer available. I have wondered if TenTec could retrofit using a PIC,
programmed using the original firmware code parameters.
I upgraded to the OMNI-VII in 2010 to avoid the potential risk of the O-6
logic board failure and retain a greater portion of my investment by selling
a working Omni 6 plus. I still have a great interest in the radio I ran for
ten years with minimal service.
73 es DX,
Gary - AB9M
-----Original Message-----
From: Dave Edwards
Sent: Thursday, January 13, 2011 8:22 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni 6 Logic Board Failure
Did they narrow it down to an unobtainable chip, or just ...bad logic board?
Some obsolete chips are hard to find, but still ...eventually...can be
found!
....Dave
----- Original Message -----
From: "Carter" <k8vt@ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, January 13, 2011 7:30 PM
Subject: Re: [TenTec] Omni 6 Logic Board Failure
> On 1/13/2011 5:39 PM, Don Steele wrote:
>> Well, my Omni 6 is in for repair, and Ten Tec has diagnosed a logic
>> board failure. Due to the unavailable chips, this means a dead radio.
>> I know this isn't the first and wont be the last of these great rigs
>> to suffer this fate. Has anyone out there come up with a fix?? Please
>> reply off line of any solutions.
>
> Let me respectfully ask why reply off line? I would think this topic
> would be of general interest to many.
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|