I replaced several in my Triton IV, Argosy, Omni-C, etc. The outside of
those cases has a square, black cover that holds the speaker element. My
Corsair II is lost... I hope on some closet shelf here... so I cannot tell
if it uses the same mounting arrangement but I thought it did. That was
some years ago and I've slept since then, though.
Sorry if doesn't seem to fit, Barry.
73, Mike N4NT
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, February 26, 2011 1:25 PM
Subject: Re: [TenTec] Corsair II speaker source?
Thanks Mike, but that speaker won't fit unless there's an easy adapter
plate that could be fashioned. I'm measuring rectangular mounting
hole spacing 3-3/8 in wide, 2 in deep.
73, Barry N1EU
On Sat, Feb 26, 2011 at 5:54 PM, Mike Hyder -N4NT-
<Mike_N4NT@charter.net> wrote:
When I studied for my commercial telegraph license, I learned of the
requirements for maintaining spare tubes. When I spent about three years
in
Ethiopia, that lesson was reinforced as to other parts as well. If what I
have will help Barry, I'll send it on out (even if Jameco denies the part
number).
73, Mike
|