And you jiggled the connections. No doubt C6 is highly suspect and cause
of many display problems. It probably should be replaced before it goes
completely bad to save on future failures.
73, Jerry, K0CQ
On 4/7/2011 3:07 AM, Daniel Schlieper wrote:
> Hi Barry,
>
> I had the same problem with my Corsair II and replaced C6 on the logic
> board. Now all is fine.
>
> See
> http://www.tentecwiki.org/doku.php?id=561dispfix
> and pictures at
> http://qrpforum.de/index.php?page=Thread&postID=49946#post49946
>
> 73 Daniel DM3DA
>
> On Wed, 6 Apr 2011, Barry N1EU wrote:
>
>> I've never mucked around with the LED freq display before but the
>> lower left vertical segment is out on ALL four digits of a Corsair LED
>> frequency display. In other words, "6" looks like "5" and "8" looks
>> like "9". Do they share something in common that would point to the
>> source of the trouble? Obvious things to check?
>>
>> Thanks& 73,
>> Barry N1EU
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|