Carl,
Is that something I can locate and adjust using Chapter 4 of the manual? I
guess if I have to ask, the answer is "no".... :)
Tom
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Carl Moreschi
Sent: Thursday, June 09, 2011 10:17 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni VI+ Frequency Display Problem Only On LSB
The internal BFO frequency adjustment for LSB is off 250 hertz.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 6/9/2011 9:59 PM, Tom Stone wrote:
> Has any owner of an Omni VI+ ever had a problem similar to this? (With the
> RIT off, Identical Side tone and Pass Band Tuning set at zero on both
rigs)
>
>
>
> Switching between my Orion II and Omni VI+ using an Alpha Delta switch on
> the same antenna. The Omni was just serviced by Ten Tec.
>
>
>
> 160M - LSB - Orion II 1.900.000 For the same voice quality (sounds the
same)
> the Omni had to be tuned to 1.899.75
>
>
>
> 80M - LSB - Orion II 3.868.000 For the same voice quality (sounds the
same)
> the Omni had to be tuned to 3.867.75
>
>
>
> Question: What could account for the consistent .25 difference in the
> frequency read out? There is no difference when I am in the USB
mode.
>
>
>
> Would appreciate any available input.
>
>
>
> 73, Tom N3XQ
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|