TenTec
[Top] [All Lists]

Re: [TenTec] Using Ten-Tec Dynamic mics with Omni VI+

To: tentec@contesting.com
Subject: Re: [TenTec] Using Ten-Tec Dynamic mics with Omni VI+
From: Jim Brown <k9yc@audiosystemsgroup.com>
Reply-to: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 20 Jun 2011 17:49:20 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 6/20/2011 3:55 PM, Richards wrote:
> For example, not all, but many, microphones exhibit what is called
> "proximity effect."  This is the tendency to produce a sound that has
> heavy bass or low frequency emphasis when you hold it very close,
> perhaps within 2 to 4 inches, to your mouth;

This is a characteristic of CARDIOID mics (one-directional) and 
bi-directional (figure-8) mics.  Omnidirectional (non-directional) mics 
do NOT have proximity effect.

One of Electro-Voice's most important mic innovations was the 
"Variable-D" microphone -- a directional mic that does NOT have 
proximity effect.  The first was the 666, also known as the "Buchannon 
Hammer," because Al Kahn's partner, Lou Burroughs, demonstrated its 
ruggedness by driving nails with it in presentations to broadcasters. 
There was a PA version called the 664. After a few years, the design got 
a bit sexier, resulting in the RE10, RE11, RE15, RE16, RE18, RE20, and 
RE27.  Shure jumped on board with their SM53 and SM54, and AKG with 
their D202 and D224, but the EV mics are the only ones that succeeded in 
the marketplace.  The EV PL20 is an RE20 made for musicians.

73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>