Check BFO oscillator alignment. It's easy to do if you have a freq
counter or accurate general coverage receiver. Instructions are in
the manual.
73, Barry N1EU
On Mon, Nov 21, 2011 at 2:13 AM, <scottsheppard@videotron.ca> wrote:
> I just recently picked up a lovely Corsair II (to add to the TT madness) and
> the DDS kit from N4YG,,,the difference, by the way, is amazing and makes the
> rig an even greater pleasure to use than before.
>
> Upon installing it and actually using the rig a bit, however, I note that my
> Tx and Rx freq are not aligned. Its not that the rig display may be a bit off
> but rather the station signal I am listening to is on one freq and when I
> transmit back, I am about 600hz off (as though working split--which I am
> not), I did not adjust anything else after the install but the issue may have
> been pre-existing.
>
> Seems to me I had similar issues on an older Omni A but don't recall what I
> tweeked or balanced...any thoughts from the Corsair crowd?
>
> 73
>
> scott va3ied
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|