You cannot make the demands of SSB greater than the demand of RTTY, etc, no
matter how you process the signal. If you follow the amplifier manufacturers
suggestions for such a key-down service, you should be more than safe. The fan
on TenTec transcievers is such insurance for them.
Dave
WA3F
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, November 30, 2011 7:10:31 PM
Subject: Re: [TenTec] Omni Speech Processor
This addressed my concerns. I suspect I am fairly safe in that I
rarely run my TT Centurion over 600 watts, about half its rated maximum
output. It seems enough power to make a difference, and it should just
loaf along with no stress at that level.
Would you concur this would allow for the extra punch from the 715
(which I rarely use if I use the amp... but sometimes I forget and have
it on when I use the amp.)
Thanks.
===================== K8JHR ===========================
On 11/30/2011 9:14 AM, CSM(r) Gary Huber wrote:
Just make sure if you use an
> amplifier with a 715, that the amplifier can handle the extra 6 dB average
> power increase and associated cooling issues.
__________________________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|