TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] Jupiter Autotuner upgrade?

from [Richards] [Permanent Link][Original]
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Jupiter Autotuner upgrade?
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 30 Nov 2011 22:23:50 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
Geeze... Rodney...   I think I could just about sell my wife to have an 
antenna like that.        ;-)

_________________________  Anonymous - K8JHR _____________________

On 11/30/2011 3:07 PM, Rodney wrote:

> my ant. is 315 ft 70ft up fed with 400 ohm ladder line to a
4 to 1 balun and I can tune 160  to 10 1to1 swr.

====================================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] Omni Speech Processor, d . e . warnick
Next by Date:  Re: [TenTec] RX366 Update, Ken Brown
Previous by Thread:  Re: [TenTec] Jupiter Autotuner upgrade?, Rodney
Next by Thread:  Re: [TenTec] Jupiter Autotuner upgrade?, Richards
Indexes:  [Date] [Thread] [Top] [All Lists]