Thanks Stephen,
It looks like at most I would need the Z10000B-U buffer amp. Thanks
Tom AA4VV
On 12/23/2011 6:11 PM, Stephen Cannon wrote:
> Tom,
> Not sure about the QS1R SDR, but it should work fine with the SDR-IQ from
> RFspace. Keep in mind that you will probably want to put a Z10000B-U buffer
> amplifier from Clifton Labs (with 0 dB gain) between the RX366 and the
> SDR-IQ or QS1R (not sure about the required gain for a QS1R, check with Jack
> Smith K8ZOA at Clifton Labs). The Z10000B-U is reasonably priced (even
> assembled tested and installed in a box).
>
> Stephen AD7TD
>
> -----Original Message-----
> From:
>
> On the RX366 board there will be a 9MHz output via TMP connector. Does
> anybody know if that means I can connect the output from the 9MHZ IF to my
> QS1R SDR receiver directly and see the waterfall display?
>
> Thanks Tom AA4VV
>
> On 12/1/2011 11:10 AM, John Henry wrote:
>> Something that I think some customers are not aware of, or have
>> missed, since this is built using the TXRX board of the Eagle, this
>> means that there is a 9MHz output available on a TMP connector. This
>> can be brought out to provide a second sweep on a PC, in addition to
>> the Main RX 9MHz IF output.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|