TenTec
[Top] [All Lists]

Re: [TenTec] RX366 Update

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] RX366 Update
From: "Stephen Cannon" <sugar_bears_home@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 23 Dec 2011 16:11:02 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Tom,
Not sure about the QS1R SDR, but it should work fine with the SDR-IQ from
RFspace.  Keep in mind that you will probably want to put a Z10000B-U buffer
amplifier from Clifton Labs (with 0 dB gain) between the RX366 and the
SDR-IQ or QS1R (not sure about the required gain for a QS1R, check with Jack
Smith K8ZOA at Clifton Labs).  The Z10000B-U is reasonably priced (even
assembled tested and installed in a box).

Stephen AD7TD

-----Original Message-----
From: 

On the RX366 board there will be a 9MHz output via TMP connector.  Does
anybody know if that means I can connect the output from the 9MHZ IF to my
QS1R SDR receiver directly and see the waterfall display?

Thanks Tom AA4VV

On 12/1/2011 11:10 AM, John Henry wrote:
> Something that I think some customers are not aware of, or have 
> missed, since this is built using the TXRX board of the Eagle, this 
> means that there is a 9MHz output available on a TMP connector. This 
> can be brought out to provide a second sweep on a PC, in addition to 
> the Main RX 9MHz IF output.

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>