| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] RX366 Update |
| From: | Tom Berry <tberry1@triad.rr.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 23 Dec 2011 16:45:34 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
On the RX366 board there will be a 9MHz output via TMP connector. Does
anybody know if that means I can connect the output from the 9MHZ IF to
my QS1R SDR receiver directly and see the waterfall display?
Thanks Tom AA4VV On 12/1/2011 11:10 AM, John Henry wrote: Something that I think some customers are not aware of, or have missed, since this is built using the TXRX board of the Eagle, this means that there is a 9MHz output available on a TMP connector. This can be brought out to provide a second sweep on a PC, in addition to the Main RX 9MHz IF output. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] T T 539, Chris Hansohn |
|---|---|
| Next by Date: | Re: [TenTec] RX366 Update, Stephen Cannon |
| Previous by Thread: | Re: [TenTec] RX366 Update, Richards |
| Next by Thread: | Re: [TenTec] RX366 Update, Stephen Cannon |
| Indexes: | [Date] [Thread] [Top] [All Lists] |